• 15mm neck sauce PET Bottle Production from PET Pre…
    Small neck sauce PET bottle is usually produced on 1-stage injection-blow system. KRONCE has carried out it by 2-stage solution successfully. 10g PET preform mold and 90cc blow mold had been running on KRONCE both injection machine and blowing machine r…
  • 36-cavity Cap Compression System
    One more 36-cavity SMCM-36 cap compression system is ready for departure. For 1.35g 29/25 cap, the system’s speed is up to 37280pcs/hour, which is equal to 64-cavity injection system’s output. Because compression mold doesn’t require hot runner, around …
  • 5gallon Lid Production on KRONCE Injection System
    Besides PET preform injection machine, general purpose injection system is also one of main product on KRONCE. Various lid, handle, thin-wall product, bucket, crate, houseware item, cutlery set, etc, can be produced on our KLS system properly. We will s…
  • Heavy Preform Mold Test
    For jumbo edible oil and drinking water bottle, the preforms are always heavy, from 80g to 130g. How to design balance of preform mold’s hot runner for this type of heavy preform is more complicated than normal light preform’s mold. The more the mold ca…
  • Automatic Blowing System for 20L Beer Container
    20L beer container likes a jumbo size gas application container with clawed shape bottom and its preform has incorporated with some additive into PET resin to protect the product inside the container. So, the key point is how to reheat this type of pref…